Browsed by
Category: JNCIS-SEC

Policy Based IPSec VPN in Juniper SRX to SRX

Policy Based IPSec VPN in Juniper SRX to SRX

Comments 493 comments

Policy Based IPSec VPN in Juniper SRX to SRX Of course The Policy Based IPSec VPN is a little bit different than Route Based IPsec VPN. Here I am going to explain and show How to configure a Policy Based IPSec VPN in Juniper SRX to SRX devices. It is configured as an example of Policy based IPSec VPN. Policy Based IPSec VPN can be implemented similarly  within different  Products like Juniper, Cisco, Fortigate, Sonic wall etc. However the policy based IPSec VPN…

Read More Read More

Site To Site IPSec VPN in Juniper SSG with one side dynamic IP
Site To Site IPSec VPN in Juniper SSG with one side dynamic IP Part 1

Site To Site IPSec VPN in Juniper SSG with one side dynamic IP Part 1

Comments 459 comments

The VPN with one side static and another side dynamic IP is a type of site to site IPSEC VPN. In this Example, I  have designed and configured Site to site IPSEC VPN in Juniper SSG series on both sides of locations. It can be implemented in the scenario where one side has static IP address and another side has dynamic IP address by replacing the desired values of VPN parameters and others. The IPSEC VPN having one side static and another side dynamic…

Read More Read More

Route Based IPSec VPN between Juniper SRX and Fortigate

Route Based IPSec VPN between Juniper SRX and Fortigate

Comments 2,632 comments

In this Example, I have designed and configured a Route-based IPSec VPN between Juniper SRX and Fortinet device. The VPN is configured in SRX of Junos 11.4 Version and Fortinet of OS 4.0 version. Both the sides of location facing internet have static IP address. The table shows Phase-I and Phase-II VPN parameters. It must be same on both side of VPN configured devices and some other parameters are locally significant. Route Based IPSec VPN between Juniper SRX and Fortigate…

Read More Read More

Site To Site IPSec VPN in Juniper SSG with one side dynamic IP
Site To Site IPSec VPN in Juniper SSG with one side dynamic IP Part 2

Site To Site IPSec VPN in Juniper SSG with one side dynamic IP Part 2

Comments 345 comments

The VPN with one side static and another side dynamic IP is a type of site to site IPSEC VPN. In this Example, I  have designed and configured Site to site IPSEC VPN in Juniper SSG with one side dynamic IP. It can be implemented in the scenario where one side has static IP address and another side has dynamic IP address by replacing the desired values of VPN parameters and others. The IPSEC VPN having one side static and another side dynamic…

Read More Read More

Configure Dynamic VPN in Juniper SRX

Configure Dynamic VPN in Juniper SRX

Comments 220 comments

Here I am going to explain and Configure  Dynamic VPN in Juniper SRX Series. It is similar to the Remote access VPN or dial-up VPN in other vendors. The dynamic  VPN is used to access the Protected Resources in somewhere securely by the remote users as it establishes policy-based IPSEC VPN tunnel between the remote clients and SRX device. The configuration here is configured in SRX210 with Junos11.4  and the same configuration will support on later released version of the…

Read More Read More